Other Testers & Calibrators

Symmetricom 58536A GPS GNSS 4-Way Active Distribution Amplifier Four Port N Conn

Part Number 58536A. This is the fastest way to get a response. We are not always available by phone. Functional Condition C4 - Used Good / F4 – Hardware Functional / Non-Data. NO EXCEPTIONS! C4 - Used Good / F4 – Hardware Functional / Non-Data.

Vintage B&K 501A Semiconductor Curve Tracer & Hickok 215 Semiconductor Analyzer

I am not an operator and don’t have the knowledge to fully test myself.

Phase II PHT-1900, Portable Hardness Tester with D Device

Used like new hardness tester. Lab kept and used very little. Great for your lab or desk.

LAB Equipment brand model AccuDrop 125 Drop Tester for package performanctesting

Thermo Electron Conductivity Calibration Kit 011220

Thermo Electron Conductivity Calibration Kit 011220. Condition is Used. Shipped with UPS Ground.

Pittsburgh Automotive Fuel Injection Pump Tester 11 Piece Kit 92699 0-100 PSI

Pittsburgh Automotive Fuel Injection Pump Tester kit, item number 92699. This 11-piece diagnostic tool set is designed to test fuel pump pressure on most systems, excluding Bosch, CIS-Jetronic, and GM throttle body systems. The gauge provides readings from 0-100 PSI and 0-7 bar. The kit includes high-pressure flex hoses with brass fittings, various adapters (1/4"-18 NPT, 1/8"-27 NPT), a barbed T-fitting, and hose clamps. Ideal for troubleshooting engine performance issues related to fuel delivery. Please note the gauge face is cracked as shown in photos. Set has not been used but crack is there.

Ideal LanTEK II Cable Certifier Tester 500 MHz Testing Unit "READ"

LANTEK II Display: P/N: 0012-00-5800. LANTEK II Remote P/N: 0012-00-5801.

Norbar Torque Transducer 500 LBFFT – 3/4" Drive In/Out

Good condition with wear from use. From government surplus.

Stahlwille Sensotork 7721-1 Transducer Lab Torque Wrench Calibration. 0,4-20Nm

Looks good.

Ideal LanTEK II Cable Certifier Tester 350 MHz CAT6e 5e LAN Testing Unit "READ"

LANTEK II Display: P/N: 0012-00-5800. LANTEK II Remote P/N: 0012-00-5801. Adapter Category 6/53 Adapter RJ45 P/N : 0012-00-0629 (TWO).

Wenzel Custom Low Phase Noise 10MHz & 100MHz Rubidium Frequency Standard Look

This is feed through a jumper on the rear panel into the External Reference Input. This allow easy use of another external reference such as a Cesium Standard. I chose the X72 because of the availability at low cost on the surplus market.

Vintage 1930's Christy supply Model 2 Electronic Tester

2008 Gilson SG-4 asphalt bulk specific gravity tester Used Needs Calibration

Test Data is saved in a format suitable for export to a spreadsheet or printer. The recently published AASHTO TP 82 Provisional Specification provides guidance for operation.

TESEQ High Voltage MD 200 High Voltage Differential Probe

The TESEQ High Voltage MD 200 High Voltage Differential Probe is a high-quality unit designed for testing and measuring purposes. Made in the United States by the reputable brand TESEQ, this probe is essential for accurately detecting high voltage differentials in electrical systems. With a unit quantity of 1, this product is a reliable tool for ensuring the integrity and functionality of electrical circuits in various industrial and commercial settings.

Vintage Shallcross Wheatstone Bridge Resistance , Percent Limit Bridge 617-G

Third party tested. Verified functional. No other information on device. WE SHIP FAST AND PACKAGE ITEMS SAFELY FROM THE WEST COAST. BUYER WILL RECEIVE THE EXACT ITEM PICTURED. USED FAIR-OK CONDITION.

Cobham TEST-A-PACK Closed Package Test Fixture F100-320-4

The Cobham TEST-A-PACK Closed Package Test Fixture F100-320-4 is an integrity leak tester fixture designed for testing closed packages with a load capability of 100-320 lbs. Made in the United States, this unit is ideal for detecting leaks in various packages and containers. With its compact and reliable design, this fixture is a valuable tool for ensuring the integrity of packaged products in a testing and inspection setting.

FLUKE 1664 FC US MULTIFUNCTION TESTER

The FLUKE 1664 FC US Multifunction Tester is a high-quality testing device manufactured by Fluke in the United States. This versatile tester is designed to accurately measure various parameters in a business or industrial setting, making it a valuable tool for ensuring quality control and efficiency in a wide range of applications. With its advanced features and reliable brand reputation, the FLUKE 1664 FC US Multifunction Tester is a top choice for professionals seeking precise and dependable measurements.

FLUKE 1550C 5KV INSULATION TESTER DIGITAL MEGHMMETER HIGH VOLTAGE

FLUKE 1550C 5KV INSULATION TESTER.

Stahlwille Sensotork 7722 Transducer Laboratry Torque Wrench Calibration 2-100Nm

Looks good.

Ametek Mansfield Twin Sealed Pressure Pump Dead Weight DM-TQ-50

However, we may occasionally overlook certain details. If you receive an item that is defective, we kindly accept it back at no cost to you. Eastern Surplus Asset.

Ideal LanTEK II Cable Certifier Tester 1000 MHz Testing Unit "READ"

Ideal LanTEK II Cable Certifier Tester 1000 MHz CAT5e CAT6 CAT6e LAN Testing Unit. LANTEK II Display: P/N: 0012-00-5800. LANTEK II Remote P/N: 0012-00-5801.

Transmation / Altek Mod Pack 91 w/ QuikCal Pressure Module

Transmation / Altek Industries Mod Pack 91 With QuikCal Pressure Module P/N: Mod Pack 91 Includes QuikCal Pressure Module & Original Carrying Case Unit Appears To Be In Good Condition - Untested Ships Promptly & Securely

Commercial Electric Pocket Size True RMS Digital Multi-Meter DMM-8132

STAHLWILLE 7707-3 Sensotork Workshop Torque Tester 7750 Display 7722 Transducer

Is just as pictured. The case is missing one latch. AGAIN: IF I DID, THEN THE PRODUCT PRICE WOULD BE HIGHER.

MSA GALAXY GX2 AUTOMATED TEST/CALIBRATION STATION UNIT FOR MSA GAS DETECTOR USE

MSA GALAXY GX2 AUTOMATED TEST/CALIBRATION STATION UNIT FOR MSA GAS DETECTOR USE

STAHLWILLE 7707- Sensotork Workshop Torque Tester 7750 Display 7721-1 Transducer

Is just as shown. Case missing one latch. AGAIN: IF I DID, THEN THE PRODUCT PRICE WOULD BE HIGHER.

HUBBELL Wet/Dry Hot Stick Tester C4033178*

Model: C4033178. MPN: C4033178. Manufacturer: HUBBELL. Type: Wet/Dry Hot Stick Assembly Tester. Provide our staff with.

GW Instek GPT-9803 AC/DC Withstanding Voltage/Insulation Resistance Tester AS-IS

Includes power cord only. Missing plastic cover from carrying handle mount.

Tanaka FC-7 Flash Point Tester Petroleum Lab ASTM D93 ISO 2719 Pensky-Marten

Fully tested and operational. Used in professional petroleum laboratory settings. Test Standards ASTM D93, IP 34, ISO 2719, JIS K2265 (Pensky-Martens Closed Cup). For Pensky-Martens closed cup flash point testing per ASTM D93 / ISO 2719 / IP 34 / JIS K2265.

Mountz M-200 USA Torque Calibrator 1a4

This was bought in returned. The buyer said that the digital display is stuck on 804. They could not figure out how to reset it and I am not an expert on these. Please realize that when you purchase this. Mountz M-200 USA Torque Calibrator, a portable handheld torque analyzer designed for verifying and calibrating torque tools

Transducer Simulator 4

Well, I don’t really know what else to say about it except that it’s a very nice unit and in excellent condition

Hipotronics HDB4ATCT-A DC Hipot Tester 4kV |POWERS ON | CLEAN INTERNALS

The Hipotronics DC Hipot Tester is a specialized device designed for testing the dielectric strength and insulation resistance of electrical components. •Sold as-is, unit only. No probes or output cables included.

AKO TORQUE TESTING SYSTEM TSD1011 1000 LB/FT TORQUE TRANSDUCER STAINLESS

NEW AKO TORQUE TESTING SYSTEM TSD1011 1000 LB/FT TORQUE TRANSDUCER STAINLESS

Huntron Scanner II 30s Compact Dual Channel Benchtop Unit for Tracker 30 USA

FLUKE 1664 FC US MULTIFUNCTION TESTER W/ TL220 LEAD KIT (TESTED) FREE SHIPPING

The Fluke 1664 FC US Multifunction Tester with TL220 Lead Kit is a high-quality tool designed for precise testing and measurement tasks in various industrial settings. Made by the trusted brand Fluke in the United States, this multifunction tester offers versatility and accuracy in a compact design. The included TL220 Lead Kit further enhances the capabilities of this product, making it a valuable asset for professionals seeking reliable testing equipment. With free shipping included, this tester is a convenient and efficient choice for those in need of a dependable testing solution.

Precision Audio Cassette Deck Alignment Gauge Tool - Solid Metal

Tool is in good used condition. Rare industrial / technical tool. Ideal for collectors or restoration work. What It’s Used For.

Hasler Bern Tachometer RPM Speed Indicator Swiss Made

Fluke 731B DC Reference Standard For Parts Or Repair

I'm Sure It Needs Cal + Switch Cleaning. As Expected On 1 + 10 Volt Range. Overall Good Condition.

Hubbell Chance Super Tester C403-2298 H-1990/ST 0-80kv Multi-Range Voltage+CASE

While specific functions vary by model, Chance testers are widely recognized in the utility and electrical industries for their role in ensuring safety and performance. This item is in used condition and may show signs of prior handling and use.

MOUNTZ M-100 ULTRA Torque Calibrator

Very good condition , thank you !!