Other
other โ pre-owned
Browse 2,490 other โ pre-owned on eBay โ listings updated every few minutes. All items are pre-owned and sold by eBay sellers directly.
New Peterson Dry Sump Oil Tank Bottom.
NOS, sold as used. Has a single. New Peterson center O-ring included as well.
C&R REMOTE OIL FILTER & DIVERTER VALVE, NEW WIX FILTER 57003R,BMRS HOSES, NASCAR
HERE IS a C & R REMOTE OIL FILTER MOUNT WITH DIVERTER VALVE AND NEW WIX FILTER. BROWN & MILLER HOSES. THEY ARE 17" & 20" LONG. IT IS FOR 1-1/2" THREAD OIL FILTERS.
Auto Verdi 6 Stage NASCAR Dry sump Pump And Lines
Auto Verdi 6 Stage dry sump pump with appropriate lines and fittings. Also included is some extra o rings and hardware. Came from top NASCAR team
2 Pack - ADD w1 Carbon fiber Air Intake Heat Shield. See Photos (9")
2 Pack - ADD w1 Carbon fiber Air Intake Heat Shield. See Photos (9")
You save $4.80
NASCAR PRC 5 STAGE ALUMINUM DRY SUMP HELICAL ROTOR OIL PUMP DIRECT PAN MOUNT 571
TURNS FINE AND EVERYTHING INSIDE LOOKS GOOD WITH TYPICAL NORMAL WEAR. THE SCAVENGE PORTS WHERE IT BOLTS TO THE OIL PAN ARE ALL O-RINGED AND ALL INCLUDE O-RINGS. THE 3/4" PORTS AND 1" PORTS HAVE PROVISION FOR O-RINGS FOR THE HARD LINES TO INSTALL, BUT MAY OR MAY NOT INCLUDE O-RINGS.
1986-95 Explorer GT40 ORIGINAL RACE PORTED intake manifold from BIGDOGS PORTING!
Fully race ported and reshaped. Look at the difference between the Edelbrock manifold and my Race ported manifold in the pictured provided. The Edelbrock cannot c ompare! The Edelbrocks runners are much smaller and flow less.
PONTIAC OLDSMOBILE HIGH TORQUE SUPER MINI STARTER 350,400,455 1.2KW 4:1 RATIO
6.6L(400) V8. 6.6L(403) V8. 7.0L(425) V8. 5.7L(350) V8. 7.5L(455) V8. CUSTOM CRUISER.
1986-95 Tubular GT40 ORIGINAL RACE PORTED manifold from BIGDOGS PORTING!
Fully race ported and reshaped. Look at the difference between the Edelbrock manifold and our Race ported manifold in the pictured provided. The Edelbrock cannot c ompare! The Edelbrocks runners are much smaller and flow less.
1961-1964 PONTIAC HIGH TORQUE MINI STARTER 389/421 RATED AT 1.4KW (2hp).
1961-1964 All Pontiac 389 / 421. 1961-1964 All V8 6.4L, 6.9L 389 AND 421 CID. Does not fit 1964_up Pontiac w/block mounted starter. Pro-Tork Mini-Max Racing Starter. (Does not fit Toronado. "Special Order")Pro-Tork starters are 1.2kw RATED AND TESTS OUT AT 1.4KW.
Ati Super Damper For 99-04 Mustang 4.6 2v OEM Size READ
As-is not tested Ati Super Damper For 99-04 Mustang 4.6 2v oem size Missing damper TORQ bolts Let me know if you have any questions or need more pictures, Iโll do my best to help.
Fuel Injector Barrel Valve Kinsler BL 8 cyl Hilborn USAC Gearte Sprint WOO USCS
This is a Used fuel Injector Barrel Valve, KINSLER BL. It was used on a 8 cylinder.
Holley 7448-1 350 CFM Carburetor 2 Barrel 7448 w/ Adapter Plate Free Shipping!
2 Barrel Holley carburetor marked "7448-1". Should be a 350 cfm model. Please verify. I am happy to send additional pics. Appears to work correctly. Unknown adapter plate included. Free Shipping.
Holley 850 BRAWLER BR67214 Elec Choke IMCA UMP WISSOTA LMS ASA Rat Rod NHRA IHRA
This is a USED Holley Carb, it is a HOLLEY 850 CFM Brawler CARB. It has 1 3/4" butterflies. It has an electric choke.
GENUINE 2013-2018 Hyundai Santa Fe Sport Occupant Sensor 88952-4Z500 OEM
The product is a genuine OEM occupant sensor for the 2013-2018 Hyundai Santa Fe Sport, with the manufacturer part number 88952-4Z500. It comes with a 1-year warranty and is classified as a performance part. This unit-ODU (PODS) sensor is designed specifically for the Hyundai Santa Fe Sport and is essential for the vehicle's performance and safety.
HKS SLD Type III-F1 Speed Limit Defencer Subaru Legacy BL5 BP5 Genuine
Up for sale is a genuine HKS SLD Type III-F1 Speed Limit Defencer that I picked up in a trade. This is the rarer one specifically made for the Subaru Legacy BL5, BP5, and BPE models (2003โ2009 era, including the B4).
C&R THERMOSTAT HOUSING -24 AN FITTINGS, JIFFY TITE QUICK FITTINGS
IT HAS JIFFY TITE QUICK CONNECT FITTINGS. HERE IS A C&R RACING THERMOSTAT HOUSING WITH COOL DOWN FITTINGS. IT IS 7" LONG, HAS -24 AN FITTINGS,ONE -6 AN FITTING WITH HOSE.
DIAGNOSTIC CARTRIDGE 2001-2006 SUBARU LEGACY IMPREZA FORESTER SELECT MONITOR
Forester Outback Legacy Impreza Baja.
1986-95 STAGE 3 Explorer GT40 Intake manifold from BIGDOGS PORTING!
The runners length has been internally shortened to 11-11.5" bolted together and the throttle body tunnel has been ported for a 80mm or larger TB and flows 1,100cfm. We added a cover plate, upper to lower bolts, upper to lower gasket, water neck and it's coated in our ceramic epoxy matte black finish.
PONTIAC OLDSMOBILE HIGH TORQUE MINI STARTER 350,400,455 1.2KW PAINTED BLACK
6.6L(400) V8. 5.7L(350) V8. 7.0L(425) V8. 6.6L(403) V8. 7.5L(455) V8. CUSTOM CRUISER.
Jesel Dogbone .903 Roller Lifters Straight Up .820 Rollers set of 16
16 set Jesel dogbone lifters All lifters are Straight Up. Have the dog bone retainer kits for sm Ford and sm Chevy listed. (((( Retainers in pic. are for Ford sm block and are offered separately.)))))
Fuel Injector Hilborn SBC 23* 2 7/16 327-C-8 #2572 Midget Kinsler Gearte USCS
This is a Used Hilborn fuel Injector for a 23 degree SBC it is COMPLETE ready to have fuel put to it. The injector has the Hoses, Nozzles, Barrel Valve and linkage. Butterflies open easily. The stacks are 2 1/2" OD and have spacers in them, the ID is about 2 3/16" and they are 7 3/4" long.
FORD MERCURY CUSTOM BIG BLOCK A/T MINI STARTER 400/429/460 RATED AT 1.4KW (2hp).
Pro-Tork's rated 1.4kw, which translates to 2hp and weighs in at an ultra light 8.5 LBS. Pro-Tork High Performance Mini Starters! Pro-Tork starters are Dyno Performance Tested and equipped with Nippon-Denso motor with gear ratio of 4:1 (most others are 3:1), and are 40% lighter than the OEM standard starter.
CV-PRODUCTS RYR SBF CRANK DRIVE Mandrel For ATI Balancer, PULLEY 5 GROOVE NASCAR
CV-PRODUCTS RYR SBF CRANK DRIVE Mandrel For ATI Balancer, PULLEY 5 GROOVE NASCAR; from a Roush yates cup motor, small chip on the pulley shouldnโt affect its performance. These are used parts though however I do have ATI balancer for a small block Nascar Ford if interested not included in this auction! Thanks for looking; Craig
NASCAR AUTO VERDI 6 STAGE ALUMINUM DRY SUMP OIL PUMP TEFLON COATED ROTORS #567
VERY EXPENSIVE HIGH QUALITY PUMP WHEN NEW. THE SHAFT IS STANDARD AUTO VERDI SIZE OF. 590". INCLUDES A 5mm PITCH 58 TOOTH PULLEY WITH COLLET STYLE HUB. THIS IS THE HALF COLLET VERSION WHERE THE TAPER IS BUILT INTO THE PULLEY AND ONLY HALF OF THE AUTO VERDI COLLECT SYSTEM IS USED AS SHOWN IN THE PICTURES.
SBC 23 Degree Shaft Mount Rockers Dirt Late Model IMCA Race Car FREE SHIP
Here is a good used set of SBC shaft rockers up for auction. These are for 23 degree heads and came off a set of SBC Pontiac alum heads. They will fit others as well such as Brodix and Darts. These have the 1.5 ratio and I do have 2 extra rockers and one shaft setup to go with them. Great used condition. Free ship in lower US
70 NASCAR ASSORTED HENDRICK ENGINES PUSHRODS 7.725"-8.300" LENGTHS x 1/2" MAIN
THIS CLEANS OFF WITH A SCOTCHBRITE PAD, BUT WE DID NOT CLEAN ANY PUSHRODS IF ANY AMOUNT OF RUST WERE PRESENT. THERE MAY ALSO BE TAPE RESIDUE WHERE THEY WERE PREVIOUSLY WRAPPED IN MASKING OR DUCT TAPE.
NASCAR BULK LOT AUTO VERDI ALUMINUM ROTOR TYPE DRY SUMP OIL PUMP ASSORTED PARTS
3 pcs. 625โ shaft (may not be Auto Verdi). YOU GET EVERYTHING PICTURED IN THE CONDITION SHOWN FOR 1 PRICE. Extra parts Few misc pressure adjuster parts as shown. CONDITION: USED. INVENTORY #925-197.
BULK 615 pcs NASCAR DEL WEST STEEL VALVE SPRING RETAINERS MINI TOPLOCK HENDRICK
HENDRICK AND OTHER CUP TEAMS HAVE RUN THESE LIGHTWEIGHT STEEL RETAINERS FOR ABOUT 20 YEARS AS THEY ARE NOT AS PRONE TO WEAR LIKE TITANIUM RETAINERS ARE. WE SOLD OFF OUR ENTIRE VALVE SPRING INVENTORY SO WE ARE LETTING ALL THESE REMAINING RETAINERS TO GET SOLD IN 1 BULK DEAL.
Nissan OEM B3781-AA500 IAC Air Regulator Valve R33 R34 GT Rb25det Neo
Rd parties!
COSWORTH 16 TOOTH GILMER STYLE WITH V-GROOVE PULLEY, FOR 1" SHAFT, NASCAR
V-GROOVE PULLEY IS 3" OD. FOR 1" SHAFT WITH 1/8" KEY WAY.
-12AN XRP REUSEABLE FITTINGS & -16 STAINLESS STEEL HOSE,
HERE IS A -12 XRP REUSEABLE FITTINGS AND -16 STAINLESS STEEL BRAIDED HOSE. THIS IS A -16 HOSE WITH -12 AN FITTINGS. 1 HOSE IS 20" LONG (TOTAL LENGTH) WITH TWO 90 FITTINGS. GOOD HOSE AND FITTINGS.
Frankland Aluminum 8 Rib Quick Change Rear End Axle Left Side Bell 4D4
The Frankland Aluminum 8 Rib Quick Change Rear End Axle Left Side Bell is a high-performance auto parts accessory designed for vehicles. With its quick change feature, it allows for easy and convenient modifications, making it a popular choice for car enthusiasts looking to enhance their vehicle's performance.
Moroso Engine Oil Accumulator 23900 Racing Nascar Hot Rod
Moroso Engine Oil Accumulators 23900. Engine Oil Accumulator, 3 Quarts, 20.125 in. x 4.25 in., Aluminum, Natural Finish, Gauge, Shut-Off Valve.
CV- PRODUCT PETERSON OIL FILTER MOUNT,1" BAR MOUNT,NASCAR, FILTER NOT INCLUDED.
HERE IS A CV PRODUCT PETERSON OIL FILTER MOUNTING BRACKET. FITS PETERSON 400 SERIES FILTERS. ITS FOR 1" OD BAR MOUNT. >>>FILTER NOT INCULDED. FILTER HOLE SIZE IS 2-7/16".
NASCAR T&D X029 HENDRICK R07.2 HEADS TITANIUM SHAFT ROCKER ARM STANDS 16 ROCKERS
THESE ONLY FIT THE HENDRICK R07.2 HEADS THAT HAVE THE SERIES NUMBER X029 ENGRAVED ON THE ENDS, WILL NOT FIT THE ECR HEADS AS THEIR BOLT PATTERN IS DIFFERENT. INCLUDES ALL 32 OF THE 1/4" STUDS (NO NUTS) AND SHAFT SPACING IS 1.300" CENTER TO CENTER.
15 NASCAR BILLET ALUMINUM 1.562" ALTERNATOR PULLEYS 3 RIB SERPENTINE BELT .668"
3 RIB SERPENTINE BELT. YOU GET ALL 15 PULLEYS FOR 1 PRICE. INVENTORY #925-139. CONDITION: USED.
8 Del West 2.250x11/32x5.475 Titanium Intake Valves
8 good used Del West titanium big block chevy valves. 2.250", 11/32" stem, 5.475" oal with .295" tip length. Square lock. Any questions, please ask.
16 Competition Cams Centered Solid Roller Lifters .842" SB Chevy
We have 16 used. 842" Competition Cams All Centered Solid Roller Lifters. for SB Chevy. The largest single source of waste paper collected for recycling is corrugated boxes. Recycling one ton of cardboard saves over 9 cubic yards of landfill space.
HAAS ALUMINUM BILLET REMOTE OIL FILTER MOUNT WITH FITTINGS, NASCAR
HERE IS a HASS ALUMINUM BILLET REMOTE OIL FILTER MOUNT WITH FITTINGS. THE FITTINGS ARE -12. IT IS FOR 1-1/2" THREAD OIL FILTERS.
RICHARDSON -16 CIRCULATORY VALVE WITH AEROQUIP QUICK CONNECTS.
AQ 5601-8-10 FEMALE. HERE IS A RICHARDSON RACING PRODUCTS COOL DOWN WATER MANIFOLD WITH QUICK CONNECT. THE MANIFOLD IS A RRP WITH -16 AN MALE AND FEMALE ENDS AND IT HAS THE SPRING FLAP VALVE INSIDE.