Racing Engines

Stage 2 6.0L LS SWAP LSX Hot Rod Swap 500hp

Flat Top Silvolite Pistons/LQ9 and Rods. New Gasket Set. BTR LS7 lifters. NGK Spark plugs TR6. 50lb GM Injectors. BTR LS9 headgaskets. New Alternator. New Water Pump.

Vintage Complete 1963 Chevy 409 QC Block Crankshaft Heads Intake Pistons

Almost Complete Engine! It is missing the water pump and carburetor. I was planning to find a car to install this in but my 'To Be Built' list is getting long again. This engine would be correct for a 1963 Chevrolet full-size car with a 4 speed, as per the suffix code.

VINTAGE CRANE CAMS Roller Lifter Hi-Rev Kit Aluminum Plates SB Chevy CAMARO NOVA

Crane Cams Roller Lifter Hi-Rev Small Block Chevy applications.

Hemi billet P&P Fabrication Dual oil Pump racing pump

Slightly used oil pump

CV Products Aluminum Pulleys - Lot of 4

Lot of 4 CV Products pulleys & misc brackets Used condition See photos for all part numbers

SYSTEM 1 REUSABLE 45 MICRON OIL FILTER, SPIN ON, BBC, FORD, MOPAR

THIS FILTER WILL FIT CHEVROLET, FORD OR MOPAR WITH INCLUDED ADAPTERS.

M&M Motors Truck Torque 6.0L Gen 4 L96 / LY6 Engine

This is our Truck Torque 6.0L Gen 4 L96 / LY6 Engine. These do require a tune as we delete VVT Function. BTR TRUCK TORQUE CAM - 30202111R1 SPECS: 202/202. 511/.511 111+1. All motors start off their life as rebuildable cores.

M&M Motors Supercharged LS3 6.2L Hot Rod Turn Key Swap with Transmission

Red Hot 6.2 LS3 Aluminum Block - 58X Reluctor. BTR LS3 Head Gaskets. M&M Motors LS3 Valley Pan Cover. When you receive your pallet simply add oil, fuel, battery, and start it up. P Series Rod Bearings.

SB Chevy Hi-Rev Kit Plates with Springs & Buttons Crane Crower Engle IMCA NHRA

Aluminum Plates / Bars with Springs & Buttons for SB Che vy. We have a used SB Chevy Hi-Rev Kit with. Look at the pictures and you decide. READ THIS BEFORE YOU BUY. We do not cancel orders. <="" p="">.

BOSS 429 XE-148003 NASCAR DRY SUMP ALUMINUM ROTOR OIL PUMP HOLMANY MOODY

Part of the Nasar dry sump system. This has the very hard to find oil pickup that is always missing.

Crane Cams Hi-Rev Kit Plates with Springs & Buttons SB Chevy IMCA NHRA

We have a used set of Crane Cams Hi-Rev Kit Plates with Springs & Buttons SB Chevy. Look at the pictures and you decide. READ THIS BEFORE YOU BUY. We do not cancel orders. <="" p="">. Keep in mind.

Ford Holman-Moody Boss 429 XE NASCAR rod bolts & nuts. Special head One Pair

This is for. Pair, enough to do one rod. Of boss 429 1/2 rod bolts.

Small Block Chevy Dry Sump Oil Pan

Fits older SBC blocks with a two piece rear main seal.Does Not fit aftermarket wide rail blocks.pan is in good condition.im assuming this is for a single stage oil pump? Feel free to message me with any additional information if you like. I’m hoping you potential buyers are smarter than myself.See all photos. It does have a small dent in it but does not leak.

Manley Titanium Valves 11890, Chrysler BB, Race Flo, 2.140 H/D 3/8” Stem, Used

These are Manley custom Titanium intake valves. They are in like new condition. There are a complete set of 8 valves. These are for big block Chrysler engines. There is no warranty implied.

Dan Olson Racing Dry Sump Oil Pan SB Chevy

Dan Olson Racing Dry Sump Oil Pan.

Holley Big Block Mopar Distributor

Have a like new Mopar dual sync distributor part number 565-203 that fits 413, 426 Wedge, 426 Hemi, and 440 engines any questions please feel free to ask Asking $450 obo Shipping to lower 48 states only Payment due within 24 hours

Moroso Aluminum Shielded Breather Tank CanReservoir with -12 AN Fitting Peterson

It has a baffle in it. Look at the pictures and you decide. READ THIS BEFORE YOU BUY. We do not cancel orders. Alaska and Hawaii usually cost about double. International is even more yet. Oct 2 09:10:56.

Moroso Stainless Steel Dry Sump SB Chevy Oil Pan from a R07

Look at the pictures and you decide. READ THIS BEFORE YOU BUY. We do not cancel orders. Alaska and Hawaii usually cost about double. International is even more yet. Oct 2 09:09:35. NO RESERVE.

Competition Engineering 78-93 Mustang torque link part # C4010

It all begins with the installation of two supplied zinc-plated brackets. Hardware and instructions included.

67 Camaro 1967 SS350 Complete Engine MU Code

1967 Camaro SS350 Small Block Chevy. This is casting number 3892657 with a L296 (Dec 29th 1966) date code. It is a V0I06MU Suffix code with a 7N170446 VIN. Heads are 462 Casting Date Coded L166 and L206 (Dec 16 and 20th 1966) Intake is casting number 3905893 with a L26 (Dec 2nd 1966) Date.

Patterson 3 Gallon Aluminum Dry Sump Oil Tank & Mounting Brackets NICE!!!!!WUJR1

We have another us ed Patterson 3 Gallon Aluminum Dry Sump Oil Tank with Mounting Brackets. The largest single source of waste paper collected for recycling is corrugated boxes. Recycling one ton of cardboard saves over 9 cubic yards of landfill space.

GM Valley Tray Magnesium Intake Manifold #12370840T for SB2.2 RARE!!!

We have another used GM Valley Tray Magnesium Intake Manifold #12370840T for SB2.2 RARE. Look at the pictures and you decide. READ THIS BEFORE YOU BUY. We do not cancel orders. Alaska and Hawaii usually cost about double.

Aluminum Dry Sump Oil Tank Sprint Car NHRA WUJR1

We have a us ed Aluminum Dry Sump Oil Tank. But is in good shape as you can see in the pictures. You might want it for your race car. This is close to: 8" x 51/2" OD x 19-1/2" Long. Alaska and Hawaii usually cost about double.

Peterson 5 Gallon Dry Sump Oil Tank with Oil filter & Brackets & 1 Heaters RS1

We have another us ed Peterson 5 Gallon Dry Sump Oil Tank with Built-In Oil filter and Mounting Brackets & 1 Heater. It has a few dings so it will be sold cheap. Look at the pictures and you decide.

Ford C9AX-8501-A Holman-Moody Boss 429 NASCAR water pump 1969 9E17 C8SE-8505-E

This is a very nice and clean ford nascar water pump. Notice the small nascar impeller and the 90 degree fitting on the top. Can be used on a mustang if you change the upper fitting. But is a true boss pump. Please feel free to ask any questions

Isky LRK-150 Ultra Roller Lifter SB Chevy Hi-Rev Kit Plates & Springs NHRA J6

We have a Used Isky LRK-150 Ultra Roller Lifter SB Chevy Hi-Rev Kit Plates & Springs. This is for Isky lifters with. 150" offset. The spring are rusty from sitting on the storage shelf. YOU HAVE TO BE AT A WORKING DESKTOP COMPUTER.

Steel Dry Sump SB Chevy Oil Pan 2 Piece Rear Seal with (2) -12 AN Fittings

We have a used Steel Dry Sump SB Chevy Oil Pan 2 Piece Rear Seal with (2) -12 AN Fittings. It is 4" deep this has (2) -12 AN Fittings. Look at the pictures and you decide. READ THIS BEFORE YOU BUY.

Crower SB Chevy Hi-Rev Kit Plates with Springs & Spacers #82327 IMCA NHRA

We have a used Crower SB Chevy Hi-Rev Kit 82327 with. Aluminum Plates / Bars with Springs & Buttons for SB Che vy. This is designed to be used with Intake offset Crower 66275 roller lifters. Look at the pictures and you decide.

For KIA Ceed 1.6 CRDi Engine Bare Perfect Tested Genuine

Lancia Ypsilon Engine Bare 46341162 Genuine 1.0 Mild Hybrid 2022 Year 42000 Km

Citroen C5 Engine Bare Type Rhr Genuine 1997Cc 100Kw 136Hp rhr 2009

Boss 429 XE-148003 Nascar aluminum double rotor oil pump Dry Sump Cast Iron

This is a super nice dual rotor boss 429 dry sump oil pump.

Orig GM 65 66 67 396 427 No Dowel Timing Cover Center Pan Bolt 7 Inch Balancer

Nice original. Glass beaded with etching primer. Best way for questions5708473608

Ford Boss 429 Mustang 1969-1970 Intake bolts & nuts Valve Cover Bolts Oem

Ford Boss 429 Mustang 1969-1970 Intake bolts & nuts Valve Cover Bolts These were used bolts out of some engines. There are slight differences in them like one intake bolt bottom, it was in the engine I’m not sure exactly. 2 different what I think are valve cover bolts also, the F is different slightly. Not 100 percent sure on these so please look at the pictures close. Thanks

Isky 150 LRK Ultra Roller Lifter SB Chevy Hi-Rev Kit Bars & Springs NHRA J7

We have a Used Isky 150 LRK Ultra Roller Lifter SB Chevy Hi-Rev Kit Bars & Springs. This is for Isky lifters with. 150" offset. YOU HAVE TO BE AT A WORKING DESKTOP COMPUTER. The largest single source of waste paper collected for recycling is corrugated boxes.

TITAN SPEED ENGINEERING SBC BILLET OIL PUMP & MSD HEX DRIVE

Used Titan oil pump.

Boss 429 XE-148003 Nascar aluminum double-rotor oil pump Dry Sump

This is a dual rotor boss 429 oil pump. Has the cast iron bottom on it. Please refer to pictures and feel free to ask any questions Thanks

Patterson Aluminum 4 Gallon Dry Sump Oil Tank & Mounting Brackets WJR1

We have another us ed Patterson Aluminum 4 Gallon Dry Sump Oil Tank with Mounting Brackets. The largest single source of waste paper collected for recycling is corrugated boxes. Recycling one ton of cardboard saves over 9 cubic yards of landfill space.

Rover 75 Engine Bare 20K4Fm49 Genuine 2.0 V6 2002 Year 80000 Km

Nissan Terrano Engine Bare Engine Type : 2953Cc 113Kw 154Hp Zd30 Automatic 2005